silviav8forums.com Forum Index
Log in Register FAQ Memberlist Search silviav8forums.com Forum Index

Terrible Experience

 
Post new topic   Reply to topic    silviav8forums.com Forum Index » Sikky MFG
View previous topic :: View next topic  
Author Message
scotheocelot
member
member


Joined: 20 Oct 2008

Posts: 235

PostPosted: Tue Aug 24, 2010 3:10 pm    Post subject: Reply with quote

Strange.

Ordered the entire kit from them on Monday. Kit arrived in 4 days complete. The driveshaft will come later when I get the measurements. Quality parts imo. I never had any trouble getting a hold of them. I have no experience with wiring. I spent the money and went speartech for my GTO harness and it was modded, tested and shipped back in 1 week.


Back to top
View user's profile Send private message
misfitrps13
member
member


Joined: 07 Mar 2010

Posts: 153
Location: Bay Area CA.

PostPosted: Tue Aug 24, 2010 11:45 pm    Post subject: Reply with quote

scotheocelot wrote:
The driveshaft will come later when I get the measurements.


I received my driveshaft at the same time along with my kit. No measuring was necessary.

Are doing something alittle different than usual with the rear diff?


Back to top
View user's profile Send private message
scotheocelot
member
member


Joined: 20 Oct 2008

Posts: 235

PostPosted: Wed Aug 25, 2010 3:00 pm    Post subject: Reply with quote

misfitrps13 wrote:
scotheocelot wrote:
The driveshaft will come later when I get the measurements.


I received my driveshaft at the same time along with my kit. No measuring was necessary.

Are doing something alittle different than usual with the rear diff?




Q45 rear end w/abs.


Back to top
View user's profile Send private message
misfitrps13
member
member


Joined: 07 Mar 2010

Posts: 153
Location: Bay Area CA.

PostPosted: Thu Aug 26, 2010 11:57 am    Post subject: Reply with quote

I think it's time for Sikky MFG to chime in and give us some response to what's going on.

Were all trying to be loyal customer's here as there are many other choices with swap kits being more available these days.


Back to top
View user's profile Send private message
rsm777
member
member


Joined: 03 Jun 2010

Posts: 280
Location: AL

PostPosted: Thu Aug 26, 2010 3:02 pm    Post subject: Reply with quote

misfitrps13 wrote:
I think it's time for Sikky MFG to chime in and give us some response to what's going on.

Were all trying to be loyal customer's here as there are many other choices with swap kits being more available these days.


Finally got a response, so N/M whine/rant over and thank you Kirk



_________________
92 Fastback 570SX
02 Camaro LS1 + T56
LS6 Hot Cam, LS6 Ported Intake, Ported TB, SIKKY Mount Kit, SIKKY 1 7/8 Headers, SIKKY D/S, SIKKY O.F. Relocation Kit, Custom 4" CAI, Mishimoto Radiator/Shroud


Last edited by rsm777 on Thu Aug 26, 2010 5:21 pm; edited 2 times in total
Back to top
View user's profile Send private message Visit poster's website
kirk
member
member


Joined: 08 Apr 2009

Posts: 953
Location: OKC

PostPosted: Thu Aug 26, 2010 4:16 pm    Post subject: Reply with quote

http://silviav8forums.com/forum/viewtopic.php?t=869

link to the manual here:

http://www.dakotadigital.com/index.cfm/page/ptype=product/product_id=126/category_id=287/home_id=59/mode=prod/prd126.htm


Basically read air's posts on page 4.

12v in to the box
Ground to the box
Speedo wire from the PCM to the "signal in"
Yellow/Black from the cluster is grounded on the box
Yellow/Blue from the cluster to OUT 1 on the box
DIP switches are UP | UP | DOWN | UP

If you car is an S13 (which I think it is from your sig), you can pull the speedo wires on the chassis from the SMJ in the drivers footwell above the fuse block. Wires should be one on top of the other in the lower right corner of the SMJ, two over from the right.
If you have an FSM look in the "foldout" section for the SMJ layout. The speedo wires should be I11 and H11.

Hows that for customer serv- oh wait...


Back to top
View user's profile Send private message Visit poster's website
willyd6869
Lv2 Member
Lv2 Member


Joined: 24 May 2010

Posts: 52

PostPosted: Thu Aug 26, 2010 11:01 pm    Post subject: Reply with quote

Yes, the sway bar is in as of a few days ago. They have told me "it would be in Wednesday" for months.


Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    silviav8forums.com Forum Index » Sikky MFG All times are GMT - 4 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001- 2004 phpBB Group
Theme created by phpBBStyles.com | Themes Database